February 17, 2011, 05:04 PM | #1 |
Junior Member
Join Date: February 17, 2011
Posts: 1
|
mossber 590 a1 problems
1st when shooting i get sprayed in the face with gas/ exuast through the safety 2nd round get stuck in the feeding tube and have to be pryed out, when this happrns its not just one round all of the have to be pried free 3rd fire pin gets stuck and will not discharge a round until after vigerous pumping any ideas? please help!!!!!!!!!!!!!!!!
|
February 17, 2011, 05:10 PM | #2 |
Senior Member
Join Date: December 14, 2009
Posts: 219
|
Your gun sounds unsafe. Bring it to a gunsmith to get checked out.. You shouldn't be sprayed in the face by hot gases via the safety...
|
February 17, 2011, 05:37 PM | #3 |
Senior Member
Join Date: January 11, 2011
Location: Jupiter, florida
Posts: 233
|
Call mossberg and use the warranty
|
February 17, 2011, 05:58 PM | #4 |
Senior Member
Join Date: March 16, 2010
Location: East Tennessee
Posts: 112
|
Send it back to Mossberg. It is unsafe. There should not be any blow back at all
|
February 17, 2011, 07:31 PM | #5 |
Senior Member
Join Date: March 11, 2009
Location: Atlanta, GA
Posts: 247
|
I wonder if Remington ever creates forum accounts and posts troubles with the competition's guns.
|
February 17, 2011, 07:33 PM | #6 |
Senior Member
Join Date: January 11, 2011
Location: Jupiter, florida
Posts: 233
|
That is verry plausable and is entirely true.
|
February 17, 2011, 07:44 PM | #7 |
Junior member
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
|
It sounds like Soilwork and Recoiljunky don't want to face the fact that Mossbergs can have problems. Are you saying that the OP is a liar?
|
February 17, 2011, 08:01 PM | #8 |
Senior Member
Join Date: March 11, 2009
Location: Atlanta, GA
Posts: 247
|
I have a Hawk 982 (imo a superior 870 express clone), and I like the 870 design. It's just that...first post... "pried/pryed"? That and the 3 problems make it seem that Mossberg didn't QC ANYTHING on their top of the line model. (I do QC for a living FYI.) This isn't the first time this possibility has crossed my mind.
|
February 17, 2011, 08:02 PM | #9 |
Senior Member
Join Date: January 11, 2011
Location: Jupiter, florida
Posts: 233
|
I'm not saying the op is a liar, working for remington or mosbergs can't break. It was in all jokeing twards the op. But on a seriouse note as stated before the gun is unsafe as it it's and needs to be sent to mossberg
|
February 17, 2011, 08:33 PM | #10 | |
Senior Member
Join Date: September 11, 2008
Posts: 1,931
|
Barrel screwed on tight?
__________________
Quote:
|
|
February 18, 2011, 02:38 PM | #11 |
Senior Member
Join Date: July 1, 2004
Location: Ohio
Posts: 415
|
Send it back to Mossberg. More than likely, they will pick up the shipping costs both ways. Your gun has a warranty. Use it.
|
Thread Tools | Search this Thread |
|
|