The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Thread Tools Search this Thread
Old October 13, 2018, 04:31 PM   #1
Junior Member
Join Date: October 2, 2018
Posts: 4
Are S&W model 10 Parts interchangeable with taurus model 80?

I have a taurus model 80 older one with a little side play in the cylinder lock up.the weapon was made in Brazil by s&w technicians with s&w tools and equipment. So my question is which is easier to get parts like cylinder stop and ejector hand ex? And second question can the Taurus 80 use sw 10 parts? Thank you.
PaleRider88 is offline  
Old October 14, 2018, 06:58 PM   #2
Senior Member
Join Date: July 26, 2005
Location: The Bluegrass
Posts: 8,577
I can't answer your specific question. However, Numrich has a large selection of gun parts, including parts for guns no longer in production. Here's the Taurus page.
KyJim is offline  
Old October 14, 2018, 07:35 PM   #3
Senior Member
Join Date: August 19, 2004
Posts: 6,880
And it was not made by S&W technicians.
DPris is offline  

gunsmithing , smith & wesson , taurus

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:18 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04594 seconds with 9 queries