The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old February 16, 2008, 10:09 PM   #26
The Lovemaster
Senior Member
 
Join Date: December 29, 2007
Location: Arizona
Posts: 416
Cast my vote for the Lee case trimmer system too, it works great. Maybe not the fastest thing, even in a drill, but simple and effective.

Rusty, I've heard of the drill bit method of removing primer crimps, haven't tried it yet. I was wondering if it was possible to ream a case off center or go too deep. Just curious, what diameter bit do you use?

Thanks for the advice!
The Lovemaster is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.02952 seconds with 10 queries