The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Thread Tools Search this Thread
Old December 3, 2012, 05:13 PM   #1
Huge Salad Fork
Junior Member
Join Date: December 3, 2012
Posts: 1
Mossberg 190DA Bolt Takedown Help

Hello, this is my first post here. I move to PA and learned that you can't hunt deer with an autoloader. So I put the 1100 back in the cabinet and brought out an old mossberg 190DA that I only shot a couple of times. It was my dad's and is a bolt action 16 gauge with a 2 shell clip that I can almost call cute (almost). I have a few questions about it but the most important is this:

How on earth do you take the bolt apart?

I have found that i can rotate the two bodies relative to one another, and that I can manually pull back and rotate the firing pin assembly. I have tried many combinations of these actions and nothing has resulted in the parts separating. I see no pins and no screws. I looked everywhere for solid information and haven't found any.

If anyone has a 185 or perhaps a 193/195 (?) they are supposed to be very similar. Thanks ahead of time.
Huge Salad Fork is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:27 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04837 seconds with 10 queries