The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Semi-automatic Forum

Thread Tools Search this Thread
Old February 19, 2019, 10:19 AM   #26
Senior Member
Join Date: February 26, 2013
Location: on the lam
Posts: 1,227
Purple Haze!
John Wayne called a revolver a pistol so it's a pistol, pilgrim.
Carmady is offline  
Old February 20, 2019, 10:57 PM   #27
Senior Member
Join Date: August 11, 2016
Posts: 876
Well, my $190 Pico in Flat Dark Earth frame arrived today from Bud's! I've only dry fired it a few times but I'm seriously impressed with the build quality and how well constructed it feels. The trigger is great! I can operate it smoothly without pulling the sights off target. I'm also used to DA triggers and this one is honestly among the smoothest I've used.

Hoping to run some rounds through it tomorrow at the range. See if I can kill some index cards at 7 yards.
OhioGuy is offline  
Old February 21, 2019, 08:06 AM   #28
Senior Member
Join Date: June 2, 2006
Location: Bowling Green Virginia
Posts: 4,366
Be sure to use snap caps when you dryfire.

Enjoy your new Pico.
PSP is offline  
Old February 21, 2019, 09:05 AM   #29
Senior Member
Join Date: August 11, 2016
Posts: 876
Has anyone put any rubber grip sleeves on a Pico, other than Talon Grips? I've seen Hogue stuff on LCP or other pocket guns and they definitely make them easier to hold.

Last edited by OhioGuy; February 21, 2019 at 01:41 PM.
OhioGuy is offline  
Old February 21, 2019, 01:29 PM   #30
Senior Member
Join Date: August 11, 2016
Posts: 876
Ran 100 rounds through it

Not bad! At 15' I could keep everything inside an 8" circle at a pretty decent rate of fire. Very easy to pull such a tiny gun to the side!

Had a lot of problems misfeeding the last round in a magazine. It would jam with the casing about halfway into the chamber. Also happened if I tried to load just a single round from a magazine. I cleaned and lubed it. Tried two different brands of round nose FMJ, Remington and Federal. About 50/50 on whether it would chamber that last round from either magazine.

One round actually had the casing peeled back from the bullet slightly.

Did anyone else have similar problems?

If I can get that resolved and practice a bit more I could see the Pico becoming a dress clothes, deep concealment tool. I'll probably never carry a gun this small unless I have to though!

Oh and the trigger on it is really good
OhioGuy is offline  
Old February 21, 2019, 05:31 PM   #31
Join Date: July 8, 2018
Posts: 26
Try cleaning and lubing the mags. Check the ser # on the Beretta web page. Early Picos subject to upgrade.
tarhealcracker is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:45 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04567 seconds with 9 queries