The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old February 2, 2011, 04:38 PM   #1
Sid
Senior Member
 
Join Date: November 22, 2009
Posts: 362
Lee Microdisk Problem

I generally use the Lee Adjustable Charge Bar to load powder into pistol cases. However, today I started to fool around with the Microdisk for the first time. I set it up exactly as shown in the directions but could not get it to work. None of the powder fell into the case. It just accumulated between the bottom of the powder hopper and the top of the disc. I would appreciate any help with this. TIA
Sid is offline  
Old February 2, 2011, 05:24 PM   #2
Doodlebugger45
Senior Member
 
Join Date: April 15, 2009
Location: Wyoming
Posts: 1,717
I'll admit I don't have the microdisk. But I'm guessing it's like the regular disks but with smaller holes? If so, are you sure the little slot on the bottom of the disk is matching up with the little tab on the base of the powder measure? When I first tried to use one of the disks that was the problem I had.
Doodlebugger45 is offline  
Old February 2, 2011, 11:18 PM   #3
Jim243
Senior Member
 
Join Date: January 5, 2009
Location: Just off Route 66
Posts: 5,067
The micro charge bar is for use with the Lee Auto Disk or Pro Auto Disk powder measure. Also are you using the pistol through die for your caliber?

If the answer is yes, then you do not have your die down enough to activate the spring and disk mover on your powder measure. Turn you die down until it moves the micro charge bar is over the opening that drops the powder into your case.


Jim
__________________
Si vis pacem, para bellum
Jim243 is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:31 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04956 seconds with 10 queries