October 1, 2002, 09:25 AM | #1 |
Senior Member
Join Date: January 9, 2002
Location: Charlotte
Posts: 332
|
sights shooting loose
I have a Gunsite Pistol with Novak low-mount sights....but the rear sight keeps shooting loose....any suggestions?
|
October 1, 2002, 09:39 AM | #2 |
Senior Member
Join Date: February 28, 2002
Location: Canton, Oh
Posts: 896
|
Lok-tite blue would be my only suggestion, Red if you really want it to stay for good..
__________________
DoD# 2223 Meum scapha volitare plenum anguillae |
October 2, 2002, 01:14 PM | #3 |
Senior Member
Join Date: June 8, 1999
Location: Tucson, Arizona Territory
Posts: 715
|
You can also tighten up the fit a bit by raising the metal under the sight. Take a sharp center punch and tap some dimples on the flat where the sight rests. It is best to do this in a "X" pattern. Don't go nuts and pound the punch into the slide, all you want to is a series of small dimples to slightly raise the metal
__________________
Joe Portale Tucson, Arizona Territory "Even now in heaven there are angles carrying savage weapons". - St Paul |
October 4, 2002, 10:21 AM | #4 |
Senior Member
Join Date: January 12, 2000
Location: Arizona
Posts: 2,302
|
Recommend you perform that on the base of the sight, rather than the dovetail of your slide. Easier and cheaper to replace the former, than the latter.
|
October 4, 2002, 03:58 PM | #5 |
Senior Member
Join Date: March 9, 2001
Location: Greenwood, SC
Posts: 875
|
In have always used Joe's procedure. It is easier to hold the rifle for center punching than to hold the sights.
__________________
NRA Endowment Member, NRA Certified Instructor CWP Holder US Army veteran Gunsmith www.boltandbarrel.com |
|
|