|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
January 23, 2017, 11:56 PM | #1 |
Senior Member
Join Date: September 12, 2015
Location: Issaquah WA. Its a dry rain.
Posts: 1,774
|
Well that escalated quickly.
Got a new lee 125 grain truncated cone mold, fired up the pot and got to work. Dropped in a 5 pounder of lead that I THOUGHT was ~10bhn, I figured it might be a good time to try a little linotype to firm em up a hair. So I knock off about a pound with the splitting wedge and drop it in the pot. Get to casting, all going well, water quench, cool, there about a hunnerd, good test foder. Chuck a couple in the PC jar and then in the oven, Im impatient. Take one over to the hardness tester......24!!!??? What in the......how the.....wow...well.
??
__________________
Just shoot the damn thing. |
January 24, 2017, 03:49 AM | #2 |
Senior Member
Join Date: August 25, 2008
Location: In the valley above the plain
Posts: 13,424
|
Been there.
Done that. Last time I fired up the pot (multiple posts about that debacle here, last year), I ended up with a bunch of BHN ~20 bullets that were supposed to have been roughly COWW (BHN ~12). And, about 9 years ago, I cast over FIVE HUNDRED bore-rider bullets for my .444 Marlin single-shot, from a single-cavity brass mold (heavy!), only to discover that I had used pure Linotype instead of the intended (softer) alloy.
__________________
Don't even try it. It's even worse than the internet would lead you to believe. |
January 24, 2017, 01:45 PM | #3 |
Senior Member
Join Date: April 8, 2000
Posts: 2,101
|
Yeah it happens every once in a while. When I do that I usually just set the whole batch aside and add it to other alloy as needed. Always pays to go slow and do a little check on things when working up a new batch.
__________________
LAter, Mike / TX |
January 24, 2017, 01:56 PM | #4 |
Senior Member
Join Date: October 21, 1998
Location: Colorado, USA
Posts: 4,308
|
While I am not a bullet caster, I do work on materials a lot.
Lead hardness has to do with grain size in some degree. There are several things which can affect grain size...cooling rate and impurities being two of the more common ones. Smaller grains is going to result in a harder bullet. Take an Oregon Trail bullet, test it, clean it, melt it and recast it. |
January 24, 2017, 05:25 PM | #5 |
Senior Member
Join Date: September 12, 2015
Location: Issaquah WA. Its a dry rain.
Posts: 1,774
|
I am wondering how much the water quenching added to the hardness.
__________________
Just shoot the damn thing. |
January 24, 2017, 09:59 PM | #6 |
Senior Member
Join Date: September 12, 2015
Location: Issaquah WA. Its a dry rain.
Posts: 1,774
|
4.6#s of pure fixed that mess right up. Now at 12.5 bhn.
__________________
Just shoot the damn thing. |
|
|