March 26, 2012, 02:52 PM | #1 |
Senior Member
Join Date: October 10, 2007
Location: Chimacum, WA
Posts: 424
|
Red Dot Problem
In order to do some work on my Buckmark I removed the Burris Trophy red dot scope. When I put it back on the image was very blurry.
Tapping gently had no effect so I removed it again. The next day I picked it up and the image was crystal clear, so I remounted it. Again the image was very blurry. I removed it again and set it aside. This morning I looked at it and the image was still a little fuzzy, but not as bad as when I removed it. I have had, and used, this scope for 2 or 3 years with no problems.
__________________
To err is human, to forgive divine Neither is Marine Corps policy... NRA Life Member |
March 26, 2012, 05:23 PM | #2 |
Senior Member
Join Date: February 8, 2008
Location: Denver, CO
Posts: 1,925
|
Check the dial to make sure it's centered on a power level number? Same for the reticle dial (if the model has multiple reticles)?
Sounds like something is being pushed out of alignment, possibly when you tighten down the mount. |
|
|