|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
March 14, 2018, 08:31 AM | #1 |
Junior Member
Join Date: July 9, 2006
Location: Princeton, NJ
Posts: 13
|
Hornady AP Projector press?
I have a chance to pick up a NON Lock and Load Hornady AP Projector press with one set of dies and two extra shell plates for $200. I am presently using a Lee Pro 1000. My question is whether $200 is a good price for that press? Is the press an outdated model, that will be a white elephant?
|
March 14, 2018, 06:47 PM | #2 |
Senior Member
Join Date: February 20, 2015
Location: Brandon Fl
Posts: 236
|
Sure it’ll work fine mate,plus you could use it as a trade for a LNL
Thewelshm |
March 15, 2018, 11:25 AM | #3 |
Senior Member
Join Date: September 6, 2006
Location: Great state of Texas
Posts: 1,077
|
I still have my ProJector... the predecessor to the LNL. I prefer it over the LNL setup, I don't care for the collets.
Parts are getting a little scarce, but they take the same shell plates as the LNL, so you aren't limited to what comes with it. In the 25 years I've been loading on my ProJector, I've never replaced one part. About every 10 years I tear it down, grease everything up and tune it a bit, no problems whatsoever.
__________________
_______________ "I have this pistol pointed at your heart!" "That is my least vulnerable spot." |
|
|