Marlin 100G extractor

Kilroy08 · August 27, 2013, 02:56 PM

Being a sucker for old .22 single shots, I picked up a Marlin 100G over the weekend.

Pleased with my purchase, I went home and set up some empty soda cans. Unsurprisingly, the rifle was dead on. Surprisingly, I had to shake the spent case out.

Apparently I overlooked the fact that the extractor was missing. I'm ordering one from Numrich in the next week or so. How do I go about installing the replacement extractor?

Dixie Gunsmithing · August 27, 2013, 08:00 PM

There is a small pin that goes through the front of the bolt that holds it in. Drift out the pin, and remove the old one, and watch to not lose the spring.

August 27, 2013, 02:56 PM	#1
Kilroy08 Senior Member Join Date: April 15, 2005 Posts: 168	Marlin 100G extractor Being a sucker for old .22 single shots, I picked up a Marlin 100G over the weekend. Pleased with my purchase, I went home and set up some empty soda cans. Unsurprisingly, the rifle was dead on. Surprisingly, I had to shake the spent case out. Apparently I overlooked the fact that the extractor was missing. I'm ordering one from Numrich in the next week or so. How do I go about installing the replacement extractor?

August 27, 2013, 08:00 PM	#2
Dixie Gunsmithing Moderator Emeritus Join Date: April 27, 2013 Location: Ohio Posts: 1,923	There is a small pin that goes through the front of the bolt that holds it in. Drift out the pin, and remove the old one, and watch to not lose the spring.