November 27, 2011, 07:06 PM | #1 |
Member
Join Date: November 27, 2011
Posts: 26
|
lee pro 1000 issues
I have a lee pro 1000 with the 40 sw dies that are a year old. My second box of 500 rounds is having issues. Every ten rounds or so i have a round that will not seat the bullet straight or will push part of the brass down. Any thoughts.
thank you |
November 27, 2011, 07:14 PM | #2 |
Senior Member
Join Date: December 5, 2008
Location: The Bald Prairie of Southern Saskatchewan, Canada
Posts: 305
|
What type of bullet are you using?
Just curious as to what type of bullet you are using. I've loaded a few thousand rounds of 9mm with a Pro 1000, and I haven't had that issue when using LRN or FMJ round nose, though I've never tried using flat nosed bullets.
Do you "ride the bullet up", that is, guide it into the seater die on the way up with your fingers? Is it just the seater die that seems to do this? Is your shell plate perhaps just a tiny bit out of line? My $0.02. Hope it helps! Cheers! McClintock |
November 27, 2011, 07:33 PM | #3 |
Member
Join Date: November 27, 2011
Posts: 26
|
I am using coper plated flat nose and i do guide it in. It is only the seating die
|
November 27, 2011, 09:13 PM | #4 | |
Senior Member
Join Date: October 12, 2002
Location: The same state as Mordor.
Posts: 5,569
|
Quote:
__________________
"As was the man of dust, so also are those who are of the dust, and as is the man of heaven, so also are those who are of heaven. Just as we have borne the image of the man of dust, we shall also bear the image of the man of heaven. " |
|
December 25, 2011, 09:54 PM | #5 |
Senior Member
Join Date: August 13, 2011
Location: Seattle area
Posts: 661
|
what lee enfield said
try putting a little more bell (open up the mouth) in the case at the powder drop station. but just a little |
December 29, 2011, 09:50 AM | #6 |
Senior Member
Join Date: June 15, 2009
Location: Minnesota CZ fan
Posts: 902
|
+ another for more bell.
|
December 29, 2011, 09:55 AM | #7 |
Senior Member
Join Date: July 28, 2007
Location: Ohio
Posts: 11,756
|
...and if it's not mouth flaring that is causing your issues... are you certain that your indexing is adjusted perfectly? There can be some damage to the nylon gear that handles the indexing if it's been monkeyed with. The nylon gears are easily replaceable and cheap, Lee may even send you a couple for free.
Run the press with no powder, primers or brass and ensure that it's indexing perfectly ALL THE TIME. Mine runs like a top once I have it adjusted, and it doesn't lose it's adjustment until I swap calibers.
__________________
Attention Brass rats and other reloaders: I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss. |
|
|