The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old October 2, 2017, 11:06 AM   #1
TrueBlue711
Senior Member
 
Join Date: March 16, 2011
Posts: 141
Marlin 336 new lever won't stay

I replaced my Marlin 336's factory standard lever with the factory big loop lever. The big loop lever didn't come with the plunger/spring/pin, so I took them out of the old one. They fit in just fine, but I'm noticing that the new lever doesn't want to stay locked in place easily. Not a huge problem since I'm holding the lever to the stock as you operate it, but just annoying when slung over your shoulder during carry. You barely bump the gun and the lever will pop out. What are the most likely reasons? Plunger too worn and need a new one? Plunger spring not strong enough? Lever too new and need some breaking in? I'm already planning on getting a new plunger, spring and pin from Midwayusa, but just wanted to see if anybody else seen this and had a good fix.
TrueBlue711 is offline  
Old October 2, 2017, 03:36 PM   #2
jonnefudge
Member
 
Join Date: November 20, 2016
Posts: 57
Yes it probably the plunger and or spring. I have tuned my marlin 1895 sbl but not yet the plunger or spring. The trick is to get it juuuust right

https://m.youtube.com/watch?v=PfCOrzrOPYk
jonnefudge is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:39 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04444 seconds with 8 queries