cetme

clean502 · February 12, 2011, 06:17 PM

Any one have a solution to the rollers on a cetme locking out before the bolt is seated ?Probably a century made rifle.It's s single shot part of the time.

SatCong · February 13, 2011, 02:52 AM

If they're sufficiently similar to HK/PTR, reverse the bolt assembly and shove it into the receiver backwards. That should compress the rollers into the bolt. Then, remove bolt assembly, turn it all around and insert as normal.
I have not handled a Cetme, but this works on my JLD.

Mike

February 12, 2011, 06:17 PM	#1
clean502 Junior Member Join Date: February 12, 2011 Posts: 2	cetme Any one have a solution to the rollers on a cetme locking out before the bolt is seated ?Probably a century made rifle.It's s single shot part of the time.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

February 13, 2011, 02:52 AM	#2
SatCong Senior Member Join Date: November 21, 2004 Location: Twangtown Posts: 175	If they're sufficiently similar to HK/PTR, reverse the bolt assembly and shove it into the receiver backwards. That should compress the rollers into the bolt. Then, remove bolt assembly, turn it all around and insert as normal. I have not handled a Cetme, but this works on my JLD. Mike