The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old February 10, 2017, 04:09 PM   #26
starsun
Junior Member
 
Join Date: March 22, 2013
Posts: 3
Reloading tables

For the most part, I use Lyman's 49th addition. During the time when powder was sparse, I would use Hodgdon and Accurate tables as well because of the additional powders I could use and were available. I just purchased Hornady's Tenth addition and then I got curious. I was going to make up some 158 g 357 mag and being low on 2400 powder I wanted to see what others I might have in stock I could use. I opened up Lyman, Hodgdon, and Hornady's charts and found a world of difference. The big question is what chart to use. In my case I will most likely stay with Lyman's and Hodgdon's and use Hornady if I decide to change my routine. I may be all wet but I think the loads here are for the more advanced reloader.
starsun is offline  
Old September 3, 2017, 04:13 AM   #27
wileybelch
Senior Member
 
Join Date: May 16, 2009
Posts: 100
I think everyone should be familiar with the authoritative listing of cartridge case brass head stamp codes. Go to www.cartridgecollectors.org/headstampcodes.
wileybelch is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05159 seconds with 10 queries