The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Thread Tools Search this Thread
Old March 12, 2013, 05:36 PM   #1
Junior Member
Join Date: March 12, 2013
Posts: 2
mec automate users help please

Hi I know its alot to ask but over here in the uk there isnt anyone I can ask. could someone please take some messurements for me in iches or mm off their auto-mate please? as been looking around now for weeks with no luck,
the messurements I need are below.

slope size,
front hight up to slope
rear hight
disk size aross disk
center of the disk to the conecting arm bolt size
lenght of arm from disk bolt to upper bolt thats on the rear of the press
and thickness of steel used for the auto mate and the disk.

If someone could do this for me it would be a great help as im trying to build a 12 volt unit as in the uk mains power is 240 volts.

Cheers Bart.
nigsbro is offline  
Old March 13, 2013, 12:11 AM   #2
Senior Member
Join Date: March 23, 2008
Location: Mid Missouri
Posts: 804
Try sending here with exactly what is needed.

mailto:[email protected]
olddrum1 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:06 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05033 seconds with 10 queries