June 7, 2018, 04:24 PM | #26 |
Senior Member
Join Date: August 25, 2008
Location: In the valley above the plain
Posts: 13,424
|
That looks like ejection damage, to me.
The cases would not do that while a bullet was still seated. And, if you look at the full size image, it looks like at least 50% of the cases have at least one ding/dent in the case mouth that should correspond with spring-loaded ejection. I don't see it listed above... What action is this rifle based on?
__________________
Don't even try it. It's even worse than the internet would lead you to believe. |
June 7, 2018, 04:30 PM | #27 |
Senior Member
Join Date: March 2, 2014
Posts: 11,771
|
It's a bolt inferring from what he's written, I think.
__________________
"Everyone speaks gun."--Robert O'Neill I am NOT an expert--I do not have any formal experience or certification in firearms use or testing; use any information I post at your own risk! |
June 7, 2018, 05:28 PM | #28 |
Senior Member
Join Date: February 19, 2010
Posts: 135
|
It's a Savage 111. I've not experienced it before, but it's probably from me ejecting a stuck case. I'm going to pay more attention and try to note the orientation when it comes out bent though.
|
June 7, 2018, 05:34 PM | #29 |
Senior Member
Join Date: March 2, 2014
Posts: 11,771
|
I have the same gun in 300 win mag--also a belted case--haven't seen that yet, I'm guessing a sizing issue--or does this also happen with factory ammo?
__________________
"Everyone speaks gun."--Robert O'Neill I am NOT an expert--I do not have any formal experience or certification in firearms use or testing; use any information I post at your own risk! |
June 7, 2018, 07:16 PM | #30 |
Junior member
Join Date: February 2, 2010
Posts: 6,846
|
"Could the rifling be gummed up enough with copper in 200 shots"
200 shots through a 7mm mag w/o cleaning? |
June 7, 2018, 10:19 PM | #31 |
Senior Member
Join Date: June 11, 2007
Posts: 2,155
|
flyboyjake, who's barrel are you using?
__________________
Semper Fi Vietnam 1965 VFW Life member NRA Life Member |
June 8, 2018, 04:01 AM | #32 |
Senior Member
Join Date: February 19, 2010
Posts: 135
|
I clean it, just not for copper fouling. But I did the other day before testing again. No change really. It's a McGowan barrel
|
|
|