The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old December 23, 2009, 10:41 PM   #1
Ar15M4
Senior Member
 
Join Date: December 21, 2009
Location: ΜΟΛΩΝ ΛАΒΕ
Posts: 150
Necking down

Lets suppose that I had a lot of 7.62 x 39 brass and I wanted to neck them down to 6.5 grendel, how would I go about doing that?

Any help would be great. Thanks.
Ar15M4 is offline  
Old December 24, 2009, 05:37 AM   #2
impalacustom
Senior Member
 
Join Date: January 26, 2009
Posts: 491
Basically you get a set of full length 6.5 Grendel dies, lube up your AK brass, run it throught the FL die, clean, load and shoot. You might have to trim it after you form it but it's fairly simple. This might help too.

http://www.brleather.net/Reloading_D...ndel.html#Make Brass
impalacustom is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04267 seconds with 8 queries