The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old June 5, 2013, 04:08 PM   #1
under_dawg
Senior Member
 
Join Date: November 15, 2007
Location: Cayce, SC
Posts: 222
Lee Zip Trim - Primer Pocket Cleaner Idea

Someone has probably arlready thought of this, but I'm going to put out there anyway. I found a neat way to clean the primer pockets of my brass with the Zip Trim. I took a 40 cal case, and wrapped a turn or two of an Avery label (electrical tape would probably work too) around the Lee pocket cleaner. Made it nice and tight and I twisted it down in the 40 cal case. Chucked it up in the Zip trim, went through 25 cases in record time with no finger cramping!! If someone has already posted this, I apologize.
under_dawg is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:00 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04847 seconds with 8 queries