|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
November 14, 2012, 10:30 PM | #1 |
Senior Member
Join Date: December 26, 2004
Location: Louisville KY
Posts: 13,806
|
SP01 owners, a question
Could you measure your factory rubber grips? I'd like to find out if they would fit my 97b, even with a slight gap toward the front.
|
November 15, 2012, 11:37 AM | #2 |
Member
Join Date: October 16, 2012
Location: Mid-Western State
Posts: 37
|
Can you tell me what precisely you want measured? Length, top width, middle, bottom, etc?
They're not a regular polygon, so a few measurements would be needed. |
November 16, 2012, 01:14 AM | #3 |
Senior Member
Join Date: December 26, 2004
Location: Louisville KY
Posts: 13,806
|
Mainly width and length. I think it might (sorta) fit on my 97b, just wondering how much gap I'll have to accept.
I fitted the factory plastic 75b grip on it and there was some 'daylight' showing from inside the frame toward the front strap. Basically just trying to find grips with the 'coke bottle' profile. CZ in their infinite wisdom decided to make the grips flat on the 97. Last edited by chris in va; November 16, 2012 at 01:24 AM. |
November 16, 2012, 09:50 PM | #4 |
Member
Join Date: October 16, 2012
Location: Mid-Western State
Posts: 37
|
Width across bevel at the top: 1"
Width across top flare: 1 3/8" Width at screw: 1 1/2" Width at CZ log: 1 1/2" Width at very bottom: 1 3/8" Length across mid-line of grip: 3 3/4" Of course, I may be off a bit here and there, but the above should be within 1/8th of an inch, probably more like a 1/16 margin of error. (SP-01, standard/base model) |
November 30, 2012, 12:21 AM | #5 |
Senior Member
Join Date: December 26, 2004
Location: Louisville KY
Posts: 13,806
|
Thank you very much!
|
|
|