September 14, 2021, 09:24 PM | #1 |
Senior Member
Join Date: November 18, 2009
Location: West of the Blue Ridge, VA
Posts: 684
|
10mm Ammo for Deer
I’m planning to hunt deer this season with my G20. Of the following 3 factory ammo loads, what would be the best choice for this task? I already have all three of these in my possession. I’ll probably limit my range to 30-40 yards.
Hornady Custom 180gr XTP Doubletap 200gr Hard Cast Buffalo Bore 220gr Hard Cas |
September 14, 2021, 09:37 PM | #2 |
Senior Member
Join Date: October 9, 2009
Location: North Alabama
Posts: 8,300
|
XTP
I don't think you'll need the extra penetration offered by the two hard cast options. Whitetails are relatively thin skinned and small boned when compared to hogs or bears, which are the intended targets of the two cast loads. Additionally, the Glock polygonal rifling is said not to be compatible with cast bullets, yielding poor accuracy and fouling. The jacketed XTP seems your best option. The XTP has a good reputation for holding together while offering useful expansion. Hunt like a bowhunter, picking your shots and angles accordingly, and I'd be quite surprised if you have any trouble.
I load XTP's in my G20 when after deer, no shots yet! |
September 14, 2021, 10:24 PM | #3 | |
Senior Member
Join Date: November 18, 2009
Location: West of the Blue Ridge, VA
Posts: 684
|
Quote:
By the way, I’ve tested the BB and Doubletap hardcast in my factory Glock barrel and they seem to shoot just fine. |
|
September 15, 2021, 04:07 AM | #4 |
Senior Member
Join Date: March 2, 2014
Posts: 11,764
|
I have a couple of G20 builds, I use longer aftermarket barrels with increased head support. 10mm might be better than nothing for a critter defense cartridge, I'd personally opt for a Lehigh defense extreme penetrator going as fast as possible. On that note, I would chrono whatever you use so that you get a realistic idea of your velocity/range/energy limitations.
sorry--got this confused with the bear defense thread where someone mentioned 10mm.
__________________
"Everyone speaks gun."--Robert O'Neill I am NOT an expert--I do not have any formal experience or certification in firearms use or testing; use any information I post at your own risk! Last edited by stagpanther; September 15, 2021 at 06:54 AM. |
September 15, 2021, 05:06 AM | #5 |
Senior Member
Join Date: February 21, 2014
Posts: 314
|
I'm not familiar with the cast offerings you listed but I'll weigh in with what experience I've had.
I've used 230gr +p in a .45 ACP and 180gr in .40 S&W to take a few deer. Both were XTP bullets and of the three deer I shot none had an exit wound (2 with the .45 and 1 with the .40) on 2 of the deer the expanded round came to rest against the ribs on the opposite side and the other resting just under the hide. The 10mm giving higher velocity may provide a bit more penetration or it may give the same penetration but expand a bit more. Either way none of these deer left anything remotely close to what I would call a trackable blood trail but died inside of a hundred yards. I've killed several deer with a 265gr .43 cal rnfp traveling at 1300 fps out of my .44. The blood trails are short and typically good, always a full passthrough. I've also taken 1 deer with a 158gr rnfp out of my 9mm traveling at 1000fps. Full passthrough with a marginal blood trail of about 75 yards or so. If it were me I'd choose one of the hardcast bullets if they shot good but that's just my opinion. |
September 15, 2021, 07:55 AM | #6 |
Senior Member
Join Date: November 18, 2009
Location: West of the Blue Ridge, VA
Posts: 684
|
I just found a limited run of Black Hills 10mm ammo, loaded with the Hornady XTP bullet, advertised around 1300 fps. I think I'll grab a box of it.
|
September 15, 2021, 06:37 PM | #7 |
Senior Member
Join Date: June 15, 2008
Location: Georgia
Posts: 10,805
|
The hardcast loads are designed for max penetration to stop large predator attacks. You don't need that for hunting deer. Most any 155 gr or heavier HP should be fine.
__________________
"If you're still doing things the same way you were doing them 10 years ago, you're doing it wrong" Winston Churchill |
September 16, 2021, 06:05 PM | #8 |
Senior Member
Join Date: October 21, 1998
Location: Colorado, USA
Posts: 4,307
|
Go with the XTPs. Shot a lot of stuff with 10mm using XTPs, other JHPs and Hardcast. I have shot an Elk with 180 XTPs at 80 yards...dropped in its' tracks.
|
September 16, 2021, 06:29 PM | #9 |
Senior Member
Join Date: November 18, 2009
Location: West of the Blue Ridge, VA
Posts: 684
|
|
September 16, 2021, 09:55 PM | #10 |
Senior Member
Join Date: October 21, 1998
Location: Colorado, USA
Posts: 4,307
|
MV of 1370.
|
September 17, 2021, 10:23 AM | #11 |
Senior Member
Join Date: April 30, 2009
Location: Cyber-world USA
Posts: 258
|
I don't see any reason it won't work as long as you keep it down to short distances & you do your part & hit the vitals.
|
September 17, 2021, 10:48 PM | #12 |
Senior Member
Join Date: April 20, 2009
Location: Helena, AL
Posts: 4,423
|
Cast won't shoot well in the Octo rifling. If I were using a 10mm, I'd go with the 200 XTP.
__________________
Reloading For: 223R, 243W, 6.5 GR, 6.5 CM, 260R, 6.5-06, 280R, 7mmRM, 300HAM'R, 308W, 30-06, 338-06, 9mm, 357M, 41M, 44SPL, 44M, 45 ACP, 45 Colt, 450BM. |
May 8, 2022, 02:59 PM | #13 |
Senior Member
Join Date: October 1, 2013
Posts: 686
|
I know this is an old thread, but IME the best bullet for 10mm hunting is the Swift A frame bullet. I am using the 180gr version and they also make a 200gr version also.
The 180gr is 1320fps from my Glock 40 and 1490fps from my 10.5 inch AR pistol. I shot a 7 point buck at 18 yards with AR pistol. The deer ran like 60 yards bleeding profusely the whole way, my nephew who has never tracked a deer before led the charge and he was able to follow the blood with zero issues at all. The bullet hit in the ribs of the onside and broke the offside shoulder and stopped under the skin. The recovered bullet was mushroomed perfectly to .678 inches and weighed 177.4 grains. For deer/hogs give me my A frames for everything else the 180 XTPS are loaded. |
May 8, 2022, 03:15 PM | #14 |
Senior Member
Join Date: November 15, 2014
Posts: 182
|
Please keep your range down to 30-40 yards. I hate the thought of a wounded deer getting .away
|
May 11, 2022, 05:19 PM | #15 |
Senior Member
Join Date: August 12, 2020
Posts: 497
|
Easy peasy ...
For deer hunting, I feed my most-awesome 6.2” 10mm Glock 40 either 200grn or 220grn poly-coated hard cast FP ammo from Underwood. UW’s poly-coating not only doesn’t lead up the factory barrel, but it imparts a “slickness” to the hard-edged FP slug that makes it feed up the ramp smoothly every time, i.e., no jams. Buffalo Bore 10mm HC ammo is good too, but it’s not coated. So you need to fire a box or two through your gun to be sure it will feed reliably.
__________________
I use the Jake Brake every chance I get. Don't care if it annoys you. Hear me now?! |
Thread Tools | Search this Thread |
|
|