Brass too clean? - Page 2

cw308 · November 22, 2017, 08:34 AM

OzeanJaeger
After I size I wet tumble the cases to remove the lube inside & out.

OzeanJaeger · November 22, 2017, 12:57 PM

Fair enough. I have nice comp dies, so I want them clean running through the press. I deprime, then anneal, then trim, then turn, then tumble, then handload. That works best for me, but certainly isn’t gospel.

Rifletom · November 22, 2017, 01:48 PM

I still dry tumble with crushed walnut media. A couple of squirts with Turtle wax "Wax abd Dry" spray in the media, 2 hours run time and viola! Clean, smooth brass cases.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

November 22, 2017, 08:34 AM	#26
cw308 Senior Member Join Date: September 2, 2010 Location: Plainview , Long Island NY Posts: 3,863	OzeanJaeger After I size I wet tumble the cases to remove the lube inside & out.

November 22, 2017, 12:57 PM	#27
OzeanJaeger Senior Member Join Date: September 8, 2014 Posts: 301	Fair enough. I have nice comp dies, so I want them clean running through the press. I deprime, then anneal, then trim, then turn, then tumble, then handload. That works best for me, but certainly isn’t gospel.

November 22, 2017, 01:48 PM	#28
Rifletom Senior Member Join Date: February 11, 2011 Location: So-Cal Posts: 786	I still dry tumble with crushed walnut media. A couple of squirts with Turtle wax "Wax abd Dry" spray in the media, 2 hours run time and viola! Clean, smooth brass cases.