|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
October 24, 2010, 08:15 PM | #1 |
Junior Member
Join Date: October 23, 2010
Posts: 8
|
600AT Magazine Replacement
Is it possible to put a mossberg 500 magazine tube on a New Haven 600AT. Mine has the anti rattle ring setup. Or possibly get a newer model tube.
|
October 25, 2010, 08:36 AM | #2 |
Senior Member
Join Date: November 26, 2007
Location: Moses Lake WA
Posts: 395
|
The Mossberg parts should all interchange. Why change? you will have to unscrew the mag tube any way, and can clean up the threads(get the sealant off) and re install after you put on the new fore arm. When you get the mag tube off you will find two rings silver soldered to the tube and a spring in front of the first one. The guns made now do not have these and will let the action tube assembly come off when you take the bolt assembly out, but they let the action tube rattle on the magazine. The hardest part is unscrewing the magazine with out damaging it. Use heat (hair dryer) and padded pliers (on the far end where the barrel bolt screws in). You will want to clamp the gun solid (being careful to not damage the frame). When you reinstall the magazine, DO NOT put lock tight back on the threads (you may need to take it off if you need to replace the mag spring), I put some grease on the threads of mine. Good luck, hope this helps.
__________________
The best gun is the one you have when you really need one |
October 25, 2010, 04:40 PM | #3 |
Junior Member
Join Date: October 23, 2010
Posts: 8
|
Sounds good to me. Thanks
|
|
|