February 22, 2018, 10:49 AM | #1 |
Member
Join Date: December 15, 2009
Posts: 57
|
Magazine help needed
I am having a problem removing the magazine on my .22 CZ 455, the problem started all of a sudden, I have cleaned the magazine port. & magazine, I have tried both the plastic and metal mags. the action screws have been adjusted and set to the proper Torrance. Thanks for any & all advise.
|
February 22, 2018, 12:58 PM | #2 |
Senior Member
Join Date: February 13, 2002
Location: Canada
Posts: 12,453
|
What kind of problem? The latch not move? Or does the mag just not come out?
The mag housing screws tight?
__________________
Spelling and grammar count! |
February 22, 2018, 01:18 PM | #3 |
Member
Join Date: December 15, 2009
Posts: 57
|
T. O'Heir, Thanks, The mag, just does not want to come out, I think the latch is operating correctly, at first I thought something was blocking the latch from compressing completely, it would appear that is not the problem unless something is jammed behind it, (it wouldn't take much) later today I am going to pick up some compressed air and spray the "H" out of it.. Again Thanks for taking the time!!
|
February 22, 2018, 01:41 PM | #4 |
Staff
Join Date: November 2, 1998
Location: Colorado
Posts: 21,824
|
With the stock removed, does the magazine lock in and come out easily?
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe! |
February 22, 2018, 10:53 PM | #5 |
Member
Join Date: December 15, 2009
Posts: 57
|
Thanks Gary, I haven't removed the stock yet, but that is what is next. I had the stock off awhile back to set the action screws, I set them with a torque driver so I am assuming they are correct, I can loosen them a little, and see what happens, Thanks for taking the time.
|
Thread Tools | Search this Thread |
|
|