|
|
|||||||
| Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Search this Thread |
February 24, 2006, 10:24 PM
|
#1 |
|
Member
Join Date: February 14, 2006
Posts: 18
|
how do you remove pressed in grips?
how would i go about removing these without breaking them?
|
|
|
February 24, 2006, 10:27 PM
|
#2 |
|
Senior Member
Join Date: October 2, 2005
Location: tennessee
Posts: 686
|
No offense but if you did break them it wouldn't diminish the value of that gun.
__________________
Scan and Breathe Scan and Breathe Stupidity should hurt |
|
|
|
February 24, 2006, 10:31 PM
|
#3 |
|
Member
Join Date: February 14, 2006
Posts: 18
|
lol yea i know...i was gonna refinish it and throw it on gunsamerica
|
|
|
|
February 25, 2006, 12:45 AM
|
#4 |
|
Senior Member
Join Date: July 9, 2004
Location: Oklahoma by birth. America by the grace of God.
Posts: 635
|
Loosen the grip screw about half way out and gently tap on the screwhead with the handle of the screwdriver until it pops the off-side panel loose. Remove that panel and reach through the grip frame with a flat tipped punch and tap at each corner until it comes loose. GO SLOW AT TAP LIGHTLY!
__________________
Quando Omni Flunkus Moritati (If all else fails - play dead!) Support the Second Amendment. Join the NRA > http://www.nra.org < Oklahoma State & Big 12 - #1 GO POKES!!!!! |
|
|
|
February 25, 2006, 07:44 PM
|
#5 |
|
Member
Join Date: February 14, 2006
Posts: 18
|
Both are pressed in ..i ended up masking them...looks alot better!
|
|
|
|
| Thread Tools | Search this Thread |
|
|
