|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
September 12, 2017, 10:40 AM | #1 |
Junior Member
Join Date: September 12, 2017
Posts: 1
|
Baby Browning Magazine Reassembly?
Hello all: I'm new here and hope I can ask a question about the Baby Browning. I took apart the original magazine (removed the follower and spring) from my 1966 Baby, cleaned it and then realized I wasn't sure which end of the spring goes up against the follower, or if it even matters (I'm aware of the back/front orientation of the spring). Both ends of the spring look pretty much the same with very minor differences (one loop is [I]slightly [I] larger than the other, but that could simply be from manufacturing.
Any help would be greatly appreciated. Many thanks, Mike |
September 12, 2017, 02:16 PM | #2 |
Senior Member
Join Date: February 13, 2006
Location: Washington state
Posts: 15,248
|
The larger loop goes to the bottom of the magazine.
__________________
Never try to educate someone who resists knowledge at all costs. But what do I know? Summit Arms Services |
September 29, 2017, 09:23 PM | #3 |
Senior Member
Join Date: June 1, 2013
Location: Now relocated to Texas
Posts: 2,943
|
Large loop down other end should be ramped to point the follower higher in the front.
|
October 2, 2017, 06:20 PM | #4 |
Senior Member
Join Date: November 30, 2012
Location: Baton Rouge, Louisiana
Posts: 1,740
|
Deleted
|
Thread Tools | Search this Thread |
|
|