July 28, 2002, 01:13 AM | #1 |
Senior Member
Join Date: November 24, 2000
Location: Aridzona
Posts: 257
|
Front Sight QC.
In a previous post I mentioned testing front sights for strength. I have heard of and seen Scattergun front sights that have come off. I always felt that silver brazing was the best way to go, but there are situations where the glued on front sight is the best option. I clean all areas with brake cleaner and remove all finish that will be under the sight. I also undercut the front bead base and install a cross pin. I have installed between 150 to 200 Scattergun front sights and have not had any come off.
If everything works right there should be a picture of my QC test. The MMC front sight is bent and torn. I bashed the Scattergun sight with a 3 pound hammer until the barrel squashed. It did not budge.
__________________
Experience is what you get when you were expecting something else. |
July 28, 2002, 07:22 AM | #2 |
Staff In Memoriam
Join Date: October 13, 1999
Location: Columbia, Md, USA
Posts: 8,811
|
Thanks, DML, I'm impressed....
|
July 28, 2002, 07:31 AM | #3 |
Senior Member
Join Date: December 20, 1998
Location: NE Pennsylvania
Posts: 3,639
|
__________________
I am no longer a member of this forum. Bye! |
|
|