|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
July 21, 2008, 01:11 PM | #1 |
Member
Join Date: July 21, 2008
Location: boise idaho
Posts: 77
|
replacing ejector spring Ruger SRH
does anyone know how to replace the ejector spring in the cylinder of a ruger SRH? I know that the ejector retainer is not to be removed. Thnx
|
July 21, 2008, 07:33 PM | #2 |
Senior Member
Join Date: December 5, 2004
Location: In the Vincent, Ohio general area.
Posts: 1,804
|
srh ruger
Sir;
When I worked for Novaks they had a SRH that had been taken apart & couldn't get it back together. They sent it out to me and I finally got it back together. To be honest, I had one awful job doing it and I seem to remember I had to make a special screwdriver to do the crane/cyl assy. I really think you would be better off to box it up and send it to Ruger - I doubt if they'd even charge you. Harry B. |
July 21, 2008, 10:49 PM | #3 |
Junior member
Join Date: July 20, 2008
Posts: 9
|
Not to be a smart aleck, but that may be something that you send back to Ruger for their kind attention.
|
July 22, 2008, 02:36 PM | #4 |
Member
Join Date: July 21, 2008
Location: boise idaho
Posts: 77
|
gunney 67 reply
thanks gentlemen, I think it is good advice. So far, no damage has been done, I was hoping to have it ready for an elk hunt this October. We'll see.
|
|
|