August 30, 2012, 03:15 PM | #1 |
Junior Member
Join Date: August 29, 2012
Posts: 2
|
Handloaded ammo issues
I'm a newbie to reloading and today fired my first rounds of 45 acp 185gr using the Hornady XTP bullet and 8.7 gns of SR 4756. A couple of observations.
1. My son's brand new Glock 30 only ejected 3 of 15 rounds. My Colt 1911 ejected all rounds. 2. Found traces of unburned powder on the range table on the ejection (right) side of the guns. Rounds had a COL of 1.150 I would appreciate any input offered. |
August 30, 2012, 03:22 PM | #2 |
Senior Member
Join Date: November 9, 2005
Location: Ohio, Appalachia's foothills.
Posts: 3,779
|
Low pressure didn't create enough force to work the slide or burn all the powder.
Smokeless powder's burn rate is controlled by pressure. If you don't create enough, the powder won't burn consistently. Short answer: Add more powder. sudo passwd root Last edited by mrawesome22; August 31, 2012 at 12:41 AM. |
August 30, 2012, 03:25 PM | #3 |
Senior Member
Join Date: May 12, 2011
Location: New Mexico
Posts: 1,315
|
I've had great results with that bullet using AA#5. That powder you used always gave me fits. Sounds like you have a low pressure load. Is the new Glock a gen4? The new springs seem to require more pressure to cycle properly, hopefully just new gun syndrome.
|
August 30, 2012, 04:11 PM | #4 |
Junior Member
Join Date: August 29, 2012
Posts: 2
|
Handload ammo issues
Thanks for the quick replies. I had suspected low pressure, since I had great difficulty finding a the correct load data for the XTP/SR4756 combination. I therefore used the low end just to be safe. I'll try bumping up the load and see what happens.
|
August 30, 2012, 04:50 PM | #5 |
Senior Member
Join Date: February 9, 2005
Location: Owego, NY
Posts: 2,000
|
You might also consider a heavier bullet.
__________________
,,, stupidity comes to some people very easily. 8/22/2017 my wife in a discussion about Liberals. Are you ready for civil war? |
August 30, 2012, 05:25 PM | #6 |
Senior Member
Join Date: December 5, 2009
Posts: 1,411
|
I prefer 5.2 grains of WST and OAL of 1.200" with that bullet. You probably are going to need to increase the pressure if you continue to use that powder.
You probably should be using a little faster burning powder. Last edited by Misssissippi Dave; August 30, 2012 at 08:41 PM. |
August 30, 2012, 06:10 PM | #7 |
Senior Member
Join Date: July 1, 2001
Posts: 6,331
|
Failure to eject and unburnt powder are sure signs of low pressure and or wrong powder. I go with low pressure, unless your data says otherwise.
You know, this is proof of the superiority of 1911's, or your recoil spring is wore out! Last, what is that powder. . .Not one of the 45 ACP staples for sure! Also, just looking at your OAL, I'm guessing it is too short. Just thinking 1.200 - 1.275" is ideal, depending on what feeds in your guns. |
August 30, 2012, 09:29 PM | #8 |
Senior Member
Join Date: March 16, 2010
Posts: 733
|
With your 185gr XTP and SR 4756, hornadys manual says 8.2-9.1gr...... COAL is 1.225
So your load wasn't super low, more mid range, but apparently not enough to cycle the glock.... more powder or a lighter recoil spring are in order perhaps.... I dont know if your too short OAL had anything to do with it.... You might try the same charge with the correct COAL and see what happens.... |
August 30, 2012, 09:37 PM | #9 |
Senior Member
Join Date: January 24, 2009
Location: Anchorage Alaska
Posts: 3,341
|
1) More powder, 2) heavier bullet and 3) lighter recoil spring have all been mentioned. One other thing can cause (or cure) your symptom.
4) How firmly you hold the gun. I have a load (don't remember now what it was) that would RELIABLY cycle or fail to cycle my 45 Colt 1911, depending on how firmly I held the gun. It made it vey convenient to practice clearance drills, as I could induce a FTE at will. And then, of course, there is 5) how much lubrication there is. Some guns like to run "dry". (Not completely without lube, of course, but drier than you might suppose.) Unburned powder is not unusual, but is something you want to minimize, as it often indicates too-low of pressure and sometimes can require a sudden field-strip and cleaning. When under fire or even just in competition, this is not a good thing. Lost Sheep |
August 31, 2012, 12:40 AM | #10 |
Senior Member
Join Date: November 9, 2005
Location: Ohio, Appalachia's foothills.
Posts: 3,779
|
|
|
|