|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
October 27, 2018, 10:05 AM | #1 |
Senior Member
Join Date: April 11, 2013
Posts: 104
|
MP9C REassembly problem
The manual's steps work for my Shield RE-assembly:
move Take Down Lever in vertical position. Guide the slide to the rear and lock. Move TDL into horizontal and release the slide forward. on my mp9c When I guide the slide onto rails the TDL starts moving upward and If I don't yank the slide fast enough rearward, the whole thing locks up. I've examined the guide rod and take down lever and don't see any obvious problems with either. |
October 27, 2018, 01:51 PM | #2 |
Senior Member
Join Date: June 19, 2012
Location: MS - USA
Posts: 899
|
My full size M&P tends to do the same thing. I just use a finger or thumb to hold the take down lever in the vertical position while guiding the slide back onto the rails.
|
|
|