The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Competition Shooting

Reply
 
Thread Tools Search this Thread
Old September 23, 2016, 05:22 PM   #1
jwrowland77
Senior Member
 
Join Date: March 23, 2012
Location: Conway, Arkansas
Posts: 1,393
Bullseye....

What's a good .45acp to start out with and do most people go open sights or some kind of red dot? If red dot, what's a decent one for this application?

The main 1911 I was looking at is the Range Officer. Any others I should look at in the same price range. Maybe $650-$850 price range...

Planning to cast 200gr SWC and load over 3.6-4.0gr of Bullseye.

TIA.

Jeremy


Sent from my iPhone using Tapatalk
jwrowland77 is offline  
Old September 24, 2016, 09:09 AM   #2
g.willikers
Senior Member
 
Join Date: September 28, 2008
Posts: 9,855
You are speaking of Bullseye the competition, rather than Bullseye the reloading powder, yes?
If so, first check the rules for the matches you are thinking of attending before buying anything.
Local rules for any of the games can vary from the standard NRA Bullseye rule book.
And, of course, definitely get that and read it thoroughly.
If nothing else it shows the folks running the matches that you are serious enough to have done that.
As for choosing between irons and a dot sight, that can depend on the distances you will be shooting and your eyesight.
Also on if the matches are indoor or outdoors, as the target distances and lighting conditions can vary quite a bit depending.
In other words, first research the matches and then the equipment.
Attend a couple to watch and learn.
__________________
Walt Kelly, alias Pogo, sez:
“Don't take life so serious, son, it ain't nohow permanent.”
g.willikers is offline  
Old September 24, 2016, 10:49 AM   #3
spacecoast
Senior Member
 
Join Date: October 14, 2009
Location: Sunshine and Keystone States
Posts: 4,440
A Range Officer is a very good choice for a starter Bullseye gun, and is a bargain for the price. At least that's what Brian Zins told me when I shot next to him and showed him mine.

Zins uses an Aimpoint Micro red dot with custom made front and rear shields, with a mount so solid he grabs the red dot to rack the slide. Of course, a setup like that adds almost as much cost as the gun itself.

I have a good number of 900 matches behind me and my Range Officer (iron sights) has never had any kind of failure. On one occasion I put 29 of 30 in the black at 50 yards with it.
spacecoast is offline  
Old September 24, 2016, 12:13 PM   #4
T. O'Heir
Senior Member
 
Join Date: February 13, 2002
Location: Canada
Posts: 7,397
Red dot dots tend to be far too big. Mind you, they're not all 2 or 3 MOA dots. Anyway, between irons or optics, it depends on the course of fire. Optics aren't allowed in all of 'em.
3.6-4.0gr of Bullseye is below minimum for a cast 200. 4.1 is the start load.
If you're thinking RO, shop around. Prices vary a lot. Cabela's is asking $699 minimum.
__________________
Spelling and grammar count!
T. O'Heir is offline  
Old October 13, 2016, 07:29 AM   #5
10Ringmagic
Senior Member
 
Join Date: October 10, 2010
Location: MI
Posts: 313
Springfield RO is indeed a good choice for starting out in bullseye competition.

I started shooting bullseye comp. last spring, and bought a Colt GCNM. Found out right away that Iron sights do not work well indoors with older eyes.

Shot that pony all summer at 50yd and 25yd with nary a problem. I just could not bring myself to have that Colt butchered up by drilling and tapping for scope base to mount a red dot for indoor 50' gallery matches.

I wound up buying a Les Baer wadcutter gun for the indoor shoots, mounted an Ultradot red dot on it, and will now use the GCNM for a "hardball" gun outdoors.

Last edited by 10Ringmagic; October 13, 2016 at 07:51 AM.
10Ringmagic is offline  
Old October 13, 2016, 10:47 AM   #6
Jim Watson
Senior Member
 
Join Date: October 25, 2001
Location: Alabama
Posts: 13,524
I don't know what the bullseye shooters are currently using, but my old High Standard has a Burris 1.1X scope made for Gil Hebard, the leading civilian shooter of his day and maybe still.
It has a 7.75 MOA dot which Mr Hebard explains will, if you zero your gun to hit under the middle of the dot and if you can hold it so the dot is anywhere in the black of the 50 yard target, assure you of a 10.

Toheir has found a "minimum load" not available to me. There have been several barge loads of .45 midrange loaded with everything from 3 to 4.5 grains of Bullseye. Lyman shows a pressure tested starting load of 3.5 grains of Bullseye with their 200 gr SWC.
Jim Watson is online now  
Old October 13, 2016, 03:25 PM   #7
David R
Senior Member
 
Join Date: January 2, 2015
Location: The swamps of WNY
Posts: 274
I shot tens of thousands of 200 swc with 3.5 Bullseye. I think it's written in stone somewhere.

Irons or optics? Last match I shot in, I was the only one on the line with irons.
David R is offline  
Old October 14, 2016, 05:15 AM   #8
darkgael
Senior Member
 
Join Date: February 9, 2006
Location: Homes in Brooklyn, NY and in Pennsylvania.
Posts: 4,785
Bullseye

The classic Bullseye match load is 4.0 grains of Bullseye powder and a 200 grain LSWC. 185 grain LSWCs and 4.5 grains of Bullseye are also popular as are 185 jacketed HPs and 4.5 grains.
I prefer a bit more zip for the long line targets with 200s and up the charge to 4.5 grains.
Red Dot sights are popular. The micro sights have the advantage of being a bit closer to the line of the bore. You want a 3 moa dot or smaller. The X-ring on the 50 yard target is slightly larger than 3 moa.
If you wish to shoot EIC matches, you will use irons. At a standard 2700 match, though, red dots dominate.

Pete
__________________
“Auto racing, bull fighting, and mountain climbing are the only real sports ... all others are games.” Ernest Hemingway ...
NRA Life Member

Last edited by darkgael; October 16, 2016 at 05:54 AM.
darkgael is offline  
Old October 14, 2016, 06:18 PM   #9
MislMan
Member
 
Join Date: July 20, 2015
Posts: 34
Range Officer with DeltaPoint red dot sight mounted in place in rear dovetail. The DP comes with mounting adapters already in the box. I shoot 200 gr lswc's using 3.7 and 4.0 gr. of Bullseye powder. Works well while getting started.
MislMan is offline  
Old October 15, 2016, 11:34 AM   #10
Nick_C_S
Senior Member
 
Join Date: March 21, 2013
Location: Taxifornia
Posts: 4,166
It's a Springfield.

I have a Springfield Mil-Spec - kind of their bottom-of-the-line 1911, if there is such a thing. And let me tell you, it is an excellent firearm all the way around. I bought it last year, and after break-in (which went as smooth as can be), it took on the task of nightstand duty - if that says anything.

My brother also has a stainless Springfield 1911. I don't know what model it is, but it has fixed sights; but a target trigger, full length guide rod, and other goodies - so it's not a low-end unit. I'm not a fan of target triggers (small hands; so I prefer the "combat" [short] style triggers); but otherwise, I love shooting it too.

I have shot other Springfields - all have been a pleasure.

Point is, it's hard to go wrong with Springfield. That much, I know.
__________________
Gun control laws benefit only criminals and politicians - but then, I repeat myself.
Nick_C_S is offline  
Old October 15, 2016, 12:13 PM   #11
g.willikers
Senior Member
 
Join Date: September 28, 2008
Posts: 9,855
Slightly off topic, but if there's 22 rimfire category at your local Bullseye matches, you might want to start there instead of with a .45.
The matches where we used to live had far more rimfire competitors than center fire.
That made for more of a fun challenge as well as a quicker learning curve to the game.
Just a thought.
__________________
Walt Kelly, alias Pogo, sez:
“Don't take life so serious, son, it ain't nohow permanent.”
g.willikers is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.12166 seconds with 8 queries