The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Thread Tools Search this Thread
Old November 27, 2001, 01:26 AM   #1
Senior Member
Join Date: October 9, 2001
Location: New Hope, PA
Posts: 230
mossy 500 20"& full magtube ?

I have a mossy with a full length magazine tube and hope to get a rifled barrel for it. Anyone know where to get one( if you can)?
MLC is offline  
Old November 27, 2001, 05:19 PM   #2
Senior Member
Join Date: October 14, 1999
Location: Gatorville, Florida
Posts: 619
No Luck So Far

Same thing on this end. Don't think that Mossy makes accessory barrels for the 20" tube. However Brownells sells the tube for the 6 shot for like $16. So with a new tube, spring, and follower your looking at roughly $20-25.
This will give you the option of having everything that Mossy makes available to you, plus you can change back to the 20" tube and barrel.
Now you also bump it up to pseudo 590 also. Pretty versitle, really.

swampgator is offline  
Old November 29, 2001, 11:52 AM   #3
Join Date: July 13, 2000
Posts: 51
Big 500 fan here...

I love the 500 series and the ability to easily change configurations to suit my needs. Have spent many hours searching the web for barrels and accesories. Mossberg makes a 20in plain bead barrel, a 28" vent rib barrel with screw in chokes, and a 20in rifle sighted barrel for the extended mag tube version.
No rifled barrels have been made for these that I can locate, and I have looked ALOT.
Gator has the right idea about gettting a shorter mag tube. Then you have access to all sorts of rifled and/or ported barrels. They are very easy to swap out once you get them unscrewed for the first time.

pmglock is offline  
Old November 29, 2001, 12:03 PM   #4
Senior Member
Join Date: October 14, 1999
Location: Gatorville, Florida
Posts: 619
Depending on...

how old the 500 is, ie number of rounds fired, the tube may screw off by hand.
However if it won't be very careful using pliers, if using vice grips open them up fully. Insert two scrap pieces of leather so the plier's "teeth" won't scratch the tube. Then slowly close jaws making sure the leather stays in place and that you don't overtighten the pliers, to avoid crushing the tube.
Or take it to your smith who SHOULD have the correct pliers to do this job. Can't see paying more than $10 for him to do it.
swampgator is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:19 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.10724 seconds with 9 queries