The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old August 16, 2013, 12:03 AM   #1
Junior Member
Join Date: August 15, 2013
Posts: 1
BAR bolt sleeve hits butt stock

BAR Mark ll 300 win mag.. when fired the bolt sleeve tail hits the stock. Bolt assemble traveled too far rearward and broke the wood out above the recessed hole in stock. Appears to be traveling about 1/4 inch to far when manually cycled. Anyone have knowledge of what would cause this to happen?
pacrat1945 is offline  
Old August 16, 2013, 06:58 AM   #2
Senior Member
Join Date: April 8, 2009
Location: Batchelor, La.
Posts: 557
Take off the forend and replace the nylon buffer. Bet it's gone allowing the machinery to travel too far. GW
Goatwhiskers is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:39 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05037 seconds with 9 queries