The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: General Handgun Forum

Thread Tools Search this Thread
Old January 8, 2013, 10:18 PM   #1
Junior Member
Join Date: January 4, 2013
Posts: 10
Opinions on Tull Ammo

I've been shooting Tull S&W .40 and have been told how bad it is but I have never had a problem. What do y'all think
REMshooter03xx is offline  
Old January 8, 2013, 10:54 PM   #2
Senior Member
Join Date: December 21, 2001
Location: Boston, People's Republic of MA
Posts: 1,541
My SW1911 has function issues with .45 TulAmmo. Either the steel used for the casings are incredibly soft or they use some type of laquer on it that shaves off easily. After a few mag fulls, it can sometimes get gritty enough to actually cause a stoppage. The slide can also lock up and become difficult to loosen up again. My Kahr Auto-Ordnance fairs better, but then again the slide to frame fit is much more loose than the SW1911.

Haven't had any issues with 9mm, but then again I've only fired a couple of boxes of it through my 92fs. Still, I've seen enough that I won't be buying it again. People say this stuff is actually Wolff ammo. Personally, I think Wolff is actually superior to this junk if you can believe it.
Proud to have served.
Brian48 is offline  
Old January 8, 2013, 11:55 PM   #3
Senior Member
Join Date: October 3, 2012
Posts: 1,083
My Ruger LCP was a single shot with TulAmmo
weblance is offline  
Old January 9, 2013, 12:06 AM   #4
Senior Member
Join Date: April 6, 2012
Location: Tennessee
Posts: 631
The only caliber I have experience with it in is 45 but my Rock Island 1911 ran through it without a problem. My only complaint would be that it seemed more likely to deflect off of things. That could just have been bad luck with the couple hundred rounds I fired though.
jasmith85 is offline  
Old January 9, 2013, 09:52 AM   #5
Senior Member
Join Date: October 20, 2007
Location: Richardson, TX
Posts: 7,333
Many shooters find that the main issue with TulAmmo is prohibitions against firing it at the local range. See here:

FWIW even if you're using it on your own property, I would encourage you to restrain from doing so during times of high fire risk, unless you take steps to mitigate the danger.
"Smokey, this is not 'Nam. This is bowling. There are rules... MARK IT ZERO!!" - Walter Sobchak
carguychris is offline  
Old January 9, 2013, 02:02 PM   #6
Senior Member
Join Date: December 1, 2009
Location: Stillwater, OKlahoma
Posts: 8,213
My CZ-75B runs it just fine,,,

My CZ-75B runs it just fine,,,
But it's the dirtiest ammo I know of.

It also runs fine in my Hi-Point 9mm Carbine,,,
It's good range fodder for spray and pray fun days.


Caje: The coward dies a thousand times, the brave only once.
Kirby: That's about all it takes, ain't it?
Combat: "A Silent Cry"
Aarond is good,,, Aarond is wise,,, Always trust Aarond! (most of the time)
aarondhgraham is offline  
Old January 9, 2013, 06:56 PM   #7
Senior Member
Join Date: December 28, 2009
Location: North Central Illinois
Posts: 1,826
My experience with Tulammo is limited to .223 in a Saiga semi auto. Feeds and functions flawlessly. Not very accurate though, at around 8 inch groups at 100 yards.

For Wolf, which is similar to Tulammo, I’ve used it in 9mm, .45acp and .223. Again, feeds and functions flawlessly. Matter of fact, I used Wolf in my Beretta 92FS one summer of combat pistol competition, and made the rank of Master. So it would be safe to say Wolf 9mm is plenty accurate.

I wouldn't hesitate a bit using Tulammo in my Beretta, just have never gotten around to trying it.
Mike38 is offline  
Old January 9, 2013, 09:50 PM   #8
Senior Member
Join Date: September 16, 2010
Location: The worst Lancaster in the U.S.
Posts: 119
I haven't shot any of it yet but I plan too. If you're really worried about it, I suggest you read this and notice that it went from 4 guns and 4 brands of ammo to 3 guns and 3 brands of ammo...
Really cool write up and a lot of info that's pretty useful to plinkers and serious shooters.
"Lube the hell out of your Llama. Run it wet and it should be a decent pistol."
BrokenBottles is offline  
Old January 9, 2013, 09:59 PM   #9
Senior Member
Join Date: June 16, 2007
Location: Ory-gun
Posts: 506
i use it for plinking ammo in my AK-74, AO 1911 and my AR. functions fine, but dirty as all get out. its good for making noise and thats about it.
Molon Labe
Mausermolt is offline  
Old January 11, 2013, 10:33 PM   #10
Senior Member
Join Date: February 6, 2009
Location: SE-SC
Posts: 412
I shoot the .45 acp in my two model 625 revolvers.I would not want to shoot it in my semi-auto's.
S&W-Keeper is offline  
Old January 11, 2013, 10:38 PM   #11
Senior Member
Join Date: May 27, 2009
Posts: 3,968
No problems other than its dirty.
Sic Semper Tyrannis
EdInk is offline  
Old January 11, 2013, 10:44 PM   #12
Senior Member
Join Date: May 12, 2002
Location: MO
Posts: 5,206
I've shot cases of it, or its predecessor Wolf, in .40, .45 and 7.62x39. The .40 runs perfectly in Glocks, S&W Sigmas & M&P's and the .45 runs fine in properly set-up 1911s, M&Ps and Glock 21s.
May a person who is relocating out-of-State move firearms with other household goods? Yes.
Sarge is offline  
Old January 11, 2013, 11:16 PM   #13
Join Date: July 4, 2012
Posts: 99
Never an issue yet in my ak. RR
ratrodney is offline  
Old January 12, 2013, 11:39 PM   #14
Senior Member
Join Date: February 8, 2010
Location: Norfolk, Va
Posts: 1,200
Never a issue with my .40, .45, or AK. Just keep in mind it is REALLLY dirty. Outside of that, no complaints.
mxsailor803 is offline  
Old January 12, 2013, 11:44 PM   #15
Senior Member
Join Date: November 11, 2010
Location: Phoenix area
Posts: 1,442
Only problem I've had is that it won't chamber in my pocket .380s. Other than that it's been great for me (.223 & 9mm).
Yung.gunr is offline  
Old January 13, 2013, 12:23 AM   #16
Senior Member
Join Date: September 3, 2006
Posts: 277
i have used tula in my .30 carbine blackhawk...the casings tend to stick in the cylinder quite often...can be annoying
BOBA FETT is offline  
Old January 13, 2013, 11:12 AM   #17
Senior Member
Join Date: July 20, 2005
Location: Indiana
Posts: 10,170
It runs fine in both my CZ-75 and S&W 1911 as well as my dad's CZ-97. My dad did have some feeding issues with it in his S&W 5906 though. While it does seem a touch dirtier, it's not difficult to clean up though in the interest of full disclosure I've not shot more than 100 rounds of it in a single range session.
Smith, and Wesson, and Me. -H. Callahan
Well waddaya know, one buwwet weft! -E. Fudd
All bad precedents begin as justifiable measures. -J. Caesar
Webleymkv is offline  
Old January 13, 2013, 11:26 AM   #18
Yankee Doodle
Senior Member
Join Date: December 5, 2004
Location: NY state
Posts: 609
Runs OK in my P-220. But, let me emphasize, it is filthy. No problems yet, but I make sure I stop and clean after every 25 - 30 rounds.
God Bless America
Yankee Doodle is offline  
Old January 13, 2013, 11:43 AM   #19
Senior Member
Join Date: February 5, 2012
Location: South Florida
Posts: 199
shouldn't be a surprise that wolf an tul ammo shoot the same since they were the same company till a couple of years ago. You can count brown and silver bear in there with em as well, all the same parent company till about 2 years ago when they parted company. I don't have all the details just recall reading an article about one of them used to be a maker for the other then going on its own an using their name still to sell under since they were in a different soviet block country and litigation however complicated that is in Russia?!

I've shot both Wolf and Tul Ammo in 5.56 and 9mm
both were extremely dirty
both were what I expected for the dirt cheap price
non re-loadable casings dirty primers and crap accuracy
you get what you pay for in life an bullets
dave9969 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:03 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.13021 seconds with 9 queries