The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old July 16, 2012, 08:51 PM   #26
lee n. field
Senior Member
Join Date: October 12, 2002
Location: The same state as Mordor.
Posts: 4,848
Interesting read. Thanks.
"As was the man of dust, so also are those who are of the dust, and as is the man of heaven, so also are those who are of heaven. Just as we have borne the image of the man of dust, we shall also bear the image of the man of heaven. "
lee n. field is offline  
Old July 16, 2012, 10:48 PM   #27
Senior Member
Join Date: March 28, 2007
Location: SOCAL
Posts: 355
The 650 has five stations. Not enough to (1)Size/decap, (2)Powder drop/expand, (3)Powder Cop, (4)Bullet Feed, (5)Seat, and, (6)Crimp separately. Only press that will do ALL THAT separately is the 1050.
Here is one of my bullet fed 650's
(2)powder drop
(3)Powder check
(4)Bullet feed and seat

FWIW without a GSI bullet feeder even the 1050 can't powder check with any other bullet feeder and seat and crimp separately. Like the 650 it only has 3 stations after the powder drop.
I stand corrected! I have never seen a GSI bullet feeder installed. Geez, that's quite a setup!!
I am the Christian Conservative that CNN warned you about!!
Waldog is offline  
Old July 17, 2012, 01:30 AM   #28
Join Date: March 6, 2012
Posts: 63
Go Dillon. I have two of them and may get a third.
judgecrater is offline  
Old July 17, 2012, 04:52 AM   #29
Senior Member
Join Date: May 25, 1999
Location: Too close to Houston
Posts: 4,196
There's only one reloading manufacturer that has a reputation for making junk.
Proud member of the NRA and Texas State Rifle Association. Registered and active voter.
Sport45 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:52 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05104 seconds with 9 queries