The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old February 14, 2001, 03:09 PM   #1
Join Date: September 10, 2000
Posts: 39
just started working with this cartridge.

in your experience, what brass is best to use. winchester, starline, remington?

thanks a bunch in advance.
fedaykin is offline  
Old February 14, 2001, 05:18 PM   #2
Staff Alumnus
Join Date: April 14, 2000
Posts: 2,926
I've always liked starline brass. That's what I was reloading .38 super with for the past few years.
ArmySon is offline  
Old February 14, 2001, 11:42 PM   #3
dick w. holliday
Senior Member
Join Date: January 13, 2001
Location: NC
Posts: 589
38 super brass

if you shoot this stuff as ipsc major none of it will last long. i use it all and don't seem to have any case failures, such as cracks. what happenes is the primer pocket gives up and will no longer hold a primer. i shoot NRA action postol and use 5.2 gr 231 which is a relative;y light load. when loading on my piggyback if i seat a primer and feel no tension at all-i take it out of shellholder and push a decapping pin through the primer hole-sometimes they will fall out-if so that one goes in the trash-if i feel any tension at all on the primer then i give that one another chance..Dick
dick w. holliday is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:14 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.11270 seconds with 9 queries