The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old January 21, 2001, 12:50 PM   #1
Join Date: March 22, 2000
Posts: 83
Bought a new A-bolt Stainless Stalker in 7-08 cal last summer. Until now, I haven't had the time to load ammo for it, so I have been shooting Remington's Premier Boattail in 140gr. Thing is, I am very pleased with the accuracy of this "store bought" round and would like to duplicate it when I begin re-loading. Any thoughts, recommendations, suggestions on how I might replicate Remington's load?

jbgood is offline  
Old January 22, 2001, 01:26 AM   #2
Senior Member
Join Date: April 22, 1999
Location: Chandler, Arizona, USA
Posts: 6,014
I would start by chronographing it find a couple of loads in your favorite manual that are close and then go from there.
Guns cause crime like spoons cause Rosie O'Donnell to be fat!

I hunt, therefore I am.
blades67 is offline  
Old January 22, 2001, 06:21 PM   #3
Senior Member
Join Date: August 7, 2000
Location: Floating down the James River in VA
Posts: 2,599
I'm not sure how you could duplicate it exactly, but some rem. brass, Rem. large rifle primers, a Sierra 140gr. boattail (I think that's what they use), and Varget as your powder might make a good load. Check Hodgdon's website for data.
Poodleshooter is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.12708 seconds with 9 queries