The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old January 19, 2001, 05:22 PM   #26
Junior member
Join Date: November 7, 1999
Posts: 1,516
I knew that the Lee dies wouldn't work in the SDB, but just didn't think about it when I was posting. Thanks for the edification.
WalterGAII is offline  
Old January 19, 2001, 05:39 PM   #27
Join Date: October 1, 2000
Posts: 28
I had that EXACT problem with my new SDB. The problem turned out to be not enough crimp. I found that if you insert a round that will not fit into a case gage or in the barrel (remove the barrel from the gun first please) and turn it with your fingers it will leave marks on the case where it rubs. This was very helpful in trying to see where the hang up was. If you are using cast bullets you will also have to keep the dies clean. I had a lot of build up in the seating station. A shop rag run down thru the seating die from the top (thru the hole) I found will remove most of the wax build up.

Hope it helps,
Dubletap45 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:24 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05169 seconds with 9 queries