The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old March 29, 2011, 07:34 PM   #1
Senior Member
Join Date: September 15, 2010
Posts: 163
.358/.416 Wildcat

Ok. I restarted this as a new post because I wanted opinions on a different aspect of the project. As earlier stated I want to take the original .416 Rigby case, neck down to .358, shorten neck to .300, push shoulder forward and increase shoulder angle to 40 degrees, and minimize case taper. My question is on pressure issues. Will the Rigby case withstand the high pressures caused by some of the modern powders, maybe H1000? Or would it be pointless the increase case capacity due to the low pressure rating of the original case. The pressure max is 47,137 psi. Any thoughts appreciated.
hhunter318 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:38 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04409 seconds with 9 queries