The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old December 14, 2010, 02:22 PM   #1
Junior Member
Join Date: December 14, 2010
Posts: 1
Problems firing 2nd round w/ PRP trigger kit in XDM .45ACP

Problems firing 2nd round with PRP trigger kit installed.
I installed a Powder River Precision (PRP) trigger kit. This is the kit without the sear. They have been sold of sears for some time.
Below is a list of the other kits installed.

PRP-045 PRP Ultimate Easy fit XDM Trigger Kit
PRP-017 Titanium Striker Status Indicator Kit
PRP-023 Titanium Striker Safety
DGR-XDM-4.5 Don's Guide Rods Model:XDm 9/40/45 4.5 inch
PRP-051 PRP Ejector $26.00 $26.00

I left out parts #53 and #54, The disassembler and the disassembly lever spring. This practice seems to be somewhat common.

When I test fired the pistol, it fired the first shot. It ejected the round and reset the striker as per the striker status pin. However, the 2nd round will not fire unless I pull back about 1/4" on the slide and release it. It is as if a safety mechanism is sticking.

This only happens when firing live ammunition. I can manually rack the slide and everything works fine.

Any ideas?
MoovinTarget is offline  

misfire , prp , safety , trigger , trigger kit

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:12 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06648 seconds with 9 queries