The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old February 11, 2010, 10:34 PM   #1
Join Date: January 16, 2010
Location: Iosco county Michigan
Posts: 39
Taurus model 85 CH Hammer swap?

I am soon going to swap my sister a weapon for a Taurus model 85 CH.

These are DA only revolvers.

Can anyone tell me if a simple hammer swap will allow me to have a SA/DA revolver, or will OTHER parts need to be switched?

I would suspect the latter, but am asking because the FIRST time I handled this weapon many years ago, I was able to thumb cock the hammer(after starting it DA) and it stayed back and fired SA.

Might have been an anomoly, but it never happened again, and I cannot do it now.

Thanks for any info.

K8vf is offline  
Old February 12, 2010, 04:29 AM   #2
Junior member
Join Date: August 8, 2007
Location: Las vegas, NV
Posts: 3,397
I'm guessing it wouldn't be worth the time or money. You can lighten up the hammer pull though, using a Worff gun spring kit.
Elvishead is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:57 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05287 seconds with 9 queries