The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 18, 2009, 09:23 PM   #1
Join Date: October 29, 2005
Posts: 82
Remington 1100 410 problems

Having problems with my 410. It has started jamming on me. It ejects fine and gets the next shell to the chamber but the end of the shell catches near the hole. I am using brand new AA 2 1/2 inch shells.Here is where I think I am going nuts.....I have shot LOTS of these shells through this gun shooting skeet with no problems at all other than an occasional rubber o ring. It does say on the barrel to shoot 3 inch only but like I said I have shot 2 1/2's in it forever. I have cleaned it very o ring and made sure the hole in the barrel was open which it was. Any ideas or did I just get lucky it shot the "Cheap" shells as long as it did???? Hopefully....thanks in advance, Doug
iudoug is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:02 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04175 seconds with 9 queries