The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Thread Tools Search this Thread
Old January 15, 2009, 09:59 PM   #1
Senior Member
Join Date: December 24, 2008
Location: Southwest Virginia
Posts: 102
Stevens stock

Has anyone worked one of these gray stocks to stiffen the fore end?
TonyAR308 is offline  
Old January 20, 2009, 04:24 PM   #2
Senior Member
Join Date: February 20, 2006
Location: West Virginia
Posts: 2,299
try an epoxy or other bedding material that is resin based. you will need a lot of release agent on the barrel to make sure you don't have a permanently attached action/barrel. Also use a couple layers of wax paper between the barrel and the stock, that way it free floats it a bit. you will only want the action and the portion of the barrel that has the chamber touching the stock and the bedding/epoxy. I did this on a hogue stock for a 10/22 and it fixed the issues of the forend flexing and touching the barrel and throwing off the groups out of the factory barrel.

Lifetime member VFW and NRA

"Quando Omni Flunkus Moritati" (when all else fails play dead) -Red Green

UniversalFrost is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:46 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04498 seconds with 9 queries