The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old December 29, 2008, 01:50 PM   #1
Senior Member
Join Date: February 20, 2006
Location: Oklahoma
Posts: 381
TEXAN shotshell reloader question......

I oughtta know this, but am gonna have to humbly ask you all for advice. I have reloaded using three old Texans for years, all 12 and 20. I recently picked up a Remi 1148 in 16 guage at the Tulsa gun show. Have also recenly found out how scarce 16 hulls are. I had previoiusly been buying 16 loaded rounds at pawn shops, et al., when I saw them, but would like to start reloading them when these get shot up and I do find hulls - - - - someday.

I know TEXAN is no more, but, like I said, I should know this, but I thought there was an outfit who more or less produced(s) parts that still fit the old presses, specifically dies.

Any help or directions on where to look appreciated.

Okie out
okiefarmer is offline  
Old December 29, 2008, 11:39 PM   #2
Senior Member
Join Date: March 23, 2008
Location: Mid Missouri
Posts: 800
Check out Graf and Sons in Mexico Missouri for you hulls. They handle a lot of hard to get stuff. On the Texan reloaders, good luck.
olddrum1 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:08 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04190 seconds with 9 queries