The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Thread Tools Search this Thread
Old December 1, 2008, 03:46 AM   #1
Junior Member
Join Date: November 26, 2008
Posts: 14
stupid 1851 Navy question

Got the gun, shot it a couple times today, can't figure out how to get the damn cylinder out. I have tried everything. any help!
ChristopherG is offline  
Old December 1, 2008, 05:21 AM   #2
Senior Member
Join Date: September 8, 2007
Location: Mississippi
Posts: 14,155
Bump the wedge out from the side opposite the screw, no need to remove the screw.With the screw in place it won't come completely out but once it's cleared the arbor slot put the revolver on half cock. Turn the cylinder till it's lined up with the ram between chambers. Lower the ram and use it to pry the barrel off. Now the cylinder will slip off the arbor. When you reinstall the barrel you might have to use a piece of wood to bump it back down on the pins. The wedge should be flush on the side opposite the screw. Drive it in too far and it will bind the cylinder.
Hawg is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:13 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03932 seconds with 9 queries