The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old November 12, 2007, 04:21 PM   #1
Join Date: April 16, 2006
Location: JAX
Posts: 33
Logical steps to put into batches

I've just gotten back into reloading, and because I've been firing factory ammo for a while, I've accumlated somewhere over 300 cases..probably enough for years of shooting. As I'm looking to experiement with "reciepies" in my two 270 rifles, while minimizing my time at the bench, I'm seeking to batch some steps to save time.

Tumble / polish -- clearly, no reason not to do them all as a single step, if in multiple batches. My objective is to get them all done, then put the tumbler away. Any tips on keeping that "freshly tumbled" shine?

Resize and seat primer: Is there any reason NOT to get all these done, and save the powder measure, bullet seating for later --- perhaps as I gather feedback on how my rifle(s) like a particular bullet and powder combo?

Your thoughts are most welcome! Thanks
Budman2 is offline  
Old November 12, 2007, 05:08 PM   #2
Join Date: August 10, 2007
Location: Lubbock, Texas
Posts: 36
As far as I know there is no reason not to do those steps together.
sknowskier is offline  
Old November 12, 2007, 05:36 PM   #3
Senior Member
Join Date: February 23, 2005
Posts: 12,871
Cleaning and polishing is really one step ( I mix the polish into my cleaning media ). As far as keeping the brass shiny - I store all my cleaned and polished brass in rubbermaid containers with lids on them ( 5 gallon tubs ) - and I keep them in my shop ( but its heated full time ). But as long as you keep the tub in a warm environment where you won't get any condensation - or big changes in temp - you should be fine.

My only reservation about depriming and re-priming and then storing them would be the same issue / just make sure you don't get any condensation or it'll be a problem. I used to store excess brass in my garage / and it would get pretty nasty looking even after a few months from condensation.
BigJimP is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:15 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04592 seconds with 9 queries