The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old March 3, 2007, 09:57 AM   #1
Senior Member
Join Date: June 7, 2005
Location: NC
Posts: 260
how far back-neck turning

Ooops should have mentioned outside neck tuner... sorry <edit<
Gents... i just aquired a Lyman neck tuner, fits on their universal case trimer,i have read a couple of articals an threads here, but my question is how far back does one cut from the mouth to the shoulder, unless i mist it, i didn't see any info explaining fully, right now i'm set up using some practice mil .308 cases an have a reasonable depth without leaving a ridge, but i'm not sure if i am going back far enough towards the shoulder, is there a proper distance... ?
thanks Richh G,...

Last edited by MrGee; March 3, 2007 at 02:31 PM.
MrGee is offline  
Old March 3, 2007, 02:19 PM   #2
Senior Member
Join Date: November 9, 2005
Location: Ohio, Appalachia's foothills.
Posts: 3,779
I only turn the inside of the necks, but I just do the whole neck. Never had a reason not to.
mrawesome22 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 04:33 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05486 seconds with 9 queries