The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Thread Tools Search this Thread
Old January 22, 2007, 06:06 PM   #1
Join Date: June 8, 2005
Posts: 25
How do you remove the barrel from a Beretta Bobcat?

I have an aftermarket barrel I want to try. Do you just punch it out or is there another trick. I have only been able to get the pin to budge a little bit with a punch. What am I doing wrong? I don't what to pound to hard on that small aluminum frame.


RFC is offline  
Old January 22, 2007, 07:05 PM   #2
Bill DeShivs
Senior Member
Join Date: April 7, 2006
Posts: 9,094
The frame should be supported on a steel bench block, over a hole that is slightly larger than the pin. If the frame is not supported in this manner there is an excellent chance that you will break it. There is a good chance you will break it anyway, so be very careful!
Bill DeShivs is offline  
Old January 22, 2007, 10:09 PM   #3
Senior Member
Join Date: November 2, 2005
Location: Arizona
Posts: 1,896
Thr odds are you will break the frame. If I was still a gambling man I would give 5 to 1 odds the frame will crack. Sorry about that, I hope I'm wrong but I've seen several parts guns that some one tried to remove the barrel.
RJay is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:57 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04834 seconds with 9 queries