The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old September 22, 2006, 09:34 AM   #1
Senior Member
Join Date: December 2, 1999
Location: Knoxville, in the Free State of Tennesse
Posts: 4,190
What size are the grip screws on a Kahr MK9?

I found a grip screw missing and went to the Kahr site to secure a replacement. $1 per screw plus $6 shipping seemed a bit high, and there was nothing else I was interested in on the site at this time. So, anyone have any idea what the screw size and thread rate is? I was hoping it wasn't proprietary to Kahr.
buzz_knox is offline  
Old September 22, 2006, 02:29 PM   #2
Senior Member
Join Date: May 4, 2001
Posts: 7,042
I DO NOT know for sure about the MK9, but my older stainless K9 uses standard 1911 grip screws that have shortened threaded portions.

I've altered 1911 screws to fit K9 and K40 guns by grinding the shanks shorter.

When shortening the screws, BE SURE to get them the same length as the Kahr screws, otherwise they will protrude into the magazine well and will scar the magazine, or cause it to jam in place.

After shortening, use a fine file to clean up the burrs left on the end to prevent cross-threading.
Dfariswheel is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:04 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04075 seconds with 9 queries