The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old September 23, 1999, 02:43 PM   #1
Senior Member
Join Date: August 28, 1999
Posts: 201
I would like to know if the X die requires no trimming like the advertizing indicates? I load a lot of 30-30 and this would sure speed up the process.

CHAINSAW is offline  
Old October 2, 1999, 09:46 PM   #2
Senior Member
Join Date: March 5, 1999
Location: Mass
Posts: 493
Thought I would bring this to the top. Asked the same question last spring and would like to know if anyone has any word on them. Also has anyone heard anything on the Lee Delux dies. A friend was saying they were supposed to cause less stretching of the case during reloading.
Colduglandon is offline  
Old October 2, 1999, 10:09 PM   #3
Senior Member
Join Date: October 29, 1998
Location: Colorado
Posts: 534
Before the first use, all brass that is to be used with the Xdie needs to be trimmed to a consistent .02 under max, IIRC.

I'm on my second loading, so it will take another one or two before I can tell if it makes a difference.
TaxPhd is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:11 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05128 seconds with 9 queries